Face to Face Courses
Entry Level Course
Off Hire Training
4 HOURS
This course is aimed at newcomers to the industry and covers off hire inspections on most models of Genie equipment.
BASIC Course
Annual Inspection
4 HOURS
This course covers the manufacturer's annual inspection requirements across a wide range of Genie equipment. Technicians will be taken step by step through the procedures listed in the maintenance inspection reports for a number of popular models.
BASIC Course
SmartLink Scissor Lifts
8 HOURS
This will provide an overall view of Genie DC Scissor Lifts with emphasis on multiplexing, motor controller, fault finding, programming and schematics (electrical & hydraulic).
BASIC Course
Diesel RT Scissor Lifts
8 HOURS
This will provide an overall view of Genie GS68, GS69 and GS90 Scissor Lifts with emphasis on multiplexing, diesel engines, fault finding, programming and schematics (electrical & hydraulic).
INTERMEDIATE Course
Introduction to Telehandlers
8 HOURS
This course explains in detail the operation of the electrical and hydraulic systems on Genie Telehandlers and includes fault finding and LMS diagnostics.
INTERMEDIATE Course
Trailer Mounted Boom Lifts
8 HOURS
This package has been developed to assist in fault finding and repair of a range of service issues relevant to the TZ34 & TZ50 Trailer Mounted Boom Lifts.
INTERMEDIATE Course
Diesel Boom Lifts
12 HOURS
This is a 1.5 day training package which has been developed to cover a wide range of materials relevant to the Genie range of diesel booms. Attendees will be trained in diagnosing and troubleshooting the ALC 500 control system, ignition start module and electrical schematics, hydraulic drive and boom functions and the oscillating axle system.
ADVANCED COURSE
Z-80/60 Boom Lift
8 HOURS
This course will provide an overview of the Z80 machine, including fault finding and calibration of machines. The diesel boom course is a pre-requisite for attending this course.
ADVANCED COURSE
ZX-135/70 Introduction
8 HOURS
This course will provide an overview of the ZX135 machine, including fault finding and control systems. The diesel boom course is a pre-requisite for attending this course.
ADVANCED COURSE
ZX-135/70 Advanced
16 HOURS
This course covers calibration and advanced troubleshooting of the ZX-135 machine. The ZX-135/70 Introduction is a required pre-requisite for attending this course.